The term ?dissipation loss? are available in the info sheet for a pressure sensor or pressure transmitter. One needs this specification to become in a position to protect the pressure sensor from overheating.
If a pressure sensor is operated in a hot environment, it usually is necessary to limit its electrical power. If one neglects this aspect, one possibly risks an overheating sufficient reason for this, in the worst case, a total failure of the instrument. Just how can Is Here be managed?
Determination of the correct electrical connection based on the dissipation loss
First, the maximum permissible electrical energy for the pressure sensor must be known. That is given in the data sheet as the dissipation loss. Please be aware that the dissipation loss could be dependent upon the utmost expected operating temperature of the instrument and should be calculated where necessary.
If the allowable dissipation loss has been determined correctly, then your actual maximum electrical power for the pressure sensor that occurs can be determined. The determination can be carried out expediently in two steps:
1. Determination of the voltage at the pressure transmitter using the following formula:
UPressure transmitter = UVoltage source ? RLoad � Imax. Current supply
2. Calculation of the utmost electrical power for the pressure transmitter through the following equation:
PPressure transmitter = UPressure transmitter � Imax. Current supply
The maximum electrical energy for the pressure transmitter (PPressure transmitter), which is now known, should be smaller than the permissible dissipation loss. If Aligned is the case, both the power (UVoltage source) and the load (RLoad) were properly calculated and the electrical energy of the pressure sensor will undoubtedly be within the permissible range under all operating conditions. Consequently, the pressure transmitter won’t heat too strongly and will withstand the mandatory operating temperatures.
Note
In the event you need any advice, your contact will gladly help you.