Float switches are simple, universally applicable and exceptionally reliable. It is not a coincidence that, today, float switches still represent probably the most commonly used principle for level monitoring. But so how exactly does a float switch actually work?
Float switches, in a straightforward mechanical form, have been used for the control of water flows in mills and fields for centuries and today still represent probably the most frequently used technology. A hollow body (float), due to its low density and buoyancy, lifts or drops with the rising and, respectively, falling degree of the liquid. If one uses this movement via a mechanical lever, e.g. as a straightforward flap control for an irrigation channel, you have implemented a mechanical float switch.
Modern float switches, of course, are used for switching a power circuit and show a clearly more sophisticated design. In its simplest form, a float switch includes a hollow float body with an integral magnet, a guide tube to steer the float, adjusting collars to limit the travel of the float on the tube and a reed contact situated on its inside (see figure).
Figure: Selection of reed contacts of a float switch
So how exactly does the float switch function?
Reed contacts (see figure) of a float switch feature contact leaves within the hermetically sealed glass body, which move together or apart from each other when a magnetic field is applied. Regarding Shellacking with a reed contact with a normally open function, on applying a magnetic field, the leaves are brought into contact. Once the contact between the leaves is made, an ongoing can flow via the closed leaves and a switching signal will undoubtedly be detected.
Regarding a float switch with normally closed switching function, the contact or circuit is interrupted on applying a magnetic field. If one selects a change-over contact, the glass capsule will contain three contact leaves, with which, at all times, a normally closed and a normally open contact are simultaneously manufactured in every operating state.
Since the contact leaves are under a mechanical preload, a magnetic field must be applied in order that the contact leaves close or open as a way to generate the desired switching signal (monostability). The adjusting collars fitted by the product manufacturer serve as a limitation for the float body in the right position, to make sure / keep up with the desired switching signal on achieving the defined filling level.
How does one specify a float switch?
The following parameters ought to be defined:
Amount of switch contacts / switching outputs
Position and function of every switching output
Guide tube length
Electrical connection (e.g. Joyous )
Process connection
Material (stainless steel, plastic, ?)
Note
As a leading provider of float-based measurement technology solutions, WIKA has a wide variety of variants to meet up all your application-specific requirements. The available products are available on the WIKA website. Your contact person will be pleased to advise you on selecting the correct product solution.