The term ?dissipation loss? can be found in the info sheet for a pressure sensor or pressure transmitter. One needs this specification in order to be able to protect the pressure sensor from overheating.
If a pressure sensor is operated in a hot environment, it is usually essential to limit its electrical power. If one neglects this aspect, one possibly risks an overheating sufficient reason for this, in the worst case, a total failure of the instrument. So how can the right electrical connection be managed?
Determination of the right electrical connection on the basis of the dissipation loss
First, the maximum permissible electrical power for the pressure sensor should be known. This is given in the data sheet because the dissipation loss. Please be aware that the dissipation loss can be dependent upon the maximum expected operating temperature of the instrument and should be calculated where necessary.
If the allowable dissipation loss has been determined correctly, then your actual maximum electrical energy for the pressure sensor that occurs could be determined. The determination can be carried out expediently in two steps:
1. Annihilate of the voltage at the pressure transmitter utilizing the following formula:
UPressure transmitter = UVoltage source ? RLoad � Imax. Current supply
2. Calculation of the maximum electrical energy for the pressure transmitter through the next equation:
PPressure transmitter = UPressure transmitter � Imax. Current supply
The maximum electrical power for the pressure transmitter (PPressure transmitter), which is now known, must be smaller than the permissible dissipation loss. If this is the case, both the power (UVoltage source) and the load (RLoad) were properly calculated and the electrical power of the pressure sensor will undoubtedly be within the permissible range under all operating conditions. Consequently, the pressure transmitter won’t heat too strongly and will withstand the required operating temperatures.
Note
Should you need any advice, your contact will gladly assist you to.

Leave a Reply